• Attach all sensors on Loom
• Owner to Supply

VP MAP Sensor       (green three pin plug)

VP Knock Sensor (different to Ecotech)

• MAT Sensor:

Long lead near Coil Pack, connect to MAT Sensor in air cleaner

• Connect Battery and Earth,
• Connect up heavy wires to Starter and alternator, and Earth to engine (not supplied)
• The computer is designed to have a direct 12 volt supply, this controls the block learn and should always be used when racing, when not racing it is recommended to use an isolator Switch or Disconnect Battery to avoid a flat Battery
• Check VP Codes as per instructions on Web site
  http://www.swresearch.com.au